Setting the DVC eyepoint
The first thing to do is move the pivot of you interior
group to the same location of the aircraft as the exterior models
pivot (you can place it outside the groups box), this is used just
like the pivot of the exterior model when in the Virtual Cockpit, as
in it is used as the referance for placing the landing gear and
Center of Gravity
Then you need to measure the distance from the pivot to
where the eyepoint needs to be, use the tape helpers for this.
Then take a note of the lengths of the tapes
Once you have these values place them in the aircraft.cfg
in the [eyepoint] section (convert them to feet if gmax is not using
feet as its unit)
BACK